Workshop - Simulating Bodies in an ABL

General goal: set up a case with a body in the ABL and run it, end to end.

The case starts from the ABL of the first workshop and adds a building to it, so the whole session is about what changes when a body of interest enters a domain that already carries a developed profile.

Agenda

Block	Topic
1	Geometry - adding the body geometry, its mesh importance and its boundary condition
2	Simulation adjustments - refinements for the body, the simulation time and the pressure exports
3	Results - visualizing and processing the pressure coefficients

Prerequisites

This session assumes that you are already familiar with the ABL simulation presented in the First ABL Simulation workshop.

You also need an account set up at solver.aerosim.io.

To run the case, that account also needs to be authorized to submit simulations. Please contact AeroSim support if it is not, before the session rather than during it.

For block 3, ParaView should already be installed on your machine.

• 1. Geometry
• 2. Simulation Adjustments
• 3. Results